anyone have any diamond hole saws?

Laura and Jim will be hosting the May meeting this Saturday the 12th and it will be the usual of food, drinks, raffle and fun.
 
Doors will be open at 6:00 pm for social talk and the meeting will start at 7:00.  Parking gets a little tight and the city says you can't park on 4th but there is a parking lot a block away.   Meeting is usually held in the backyard so feel free to bring your favorite lawn chair, weather permitting of course.

If you need address/directions, contact a club member.

Best if you park at Mini Mall (where the spaghetti establishment use to be)
 
You will get to see his new frag tank set up in the making.
 
Hope to see you there!

•    About the Club
•    MCMAC 2009
•    Constitution
•    Bylaws

[Guest]

Welcome, Guest.
Please login or register.

1 Hour 1 Day 1 Week 1 Month Forever

Login with username, password and session length

[na.lamar]

I'm building a new tank since the last one I had broke.  And was wondering if anyone had a 1 1/8" or 1 7/16" or 1 1/2" diamond hole saw I could borrow or rent from them.  Or anyone know a place locally that will drill and how much they charge per hole? 

Thanks, Nathan

[sscherin]

I have a 39mm (1.5") around here somewhere but I can't find it..
Drilling for 3/4" bulkheads right?

All I can find in the cabinet right now is the 45mm for 1" bulkheads.
You can borrow that one if you want.

If you can wait 2 weeks order a new one from www.richontools.com
It'll cost you about $5.30 for a 39mm shipped and take 2 weeks to arrive from Hong Kong.
http://www.richontools.com/catalog/i630.html

[na.lamar]

Ya I'm drilling 3/4" bulkhead.  I was thinking about using a diamond tip dremel bit since the hole doesn't really have to be perfectly round but I don't know